Chapter 3 Hardware
NWA/WAC/WAX Series User’s Guide
59
Figure 27 WAC5302D-S LEDs
The following table describes the LEDs.
Table 19 WAC5302D-S LEDs
LED COLOR STATUS DESCRIPTION
PWR/SYS Amber Blinks between amber
and green alternately
(1 second interval).
The LED blinks amber and green alternately when the
WAC is booting up.
Green
Green On The Zyxel Device is ready for use.
Slow Blinking (On for 1s,
Off for 1s)
The wireless module of the Zyxel Device is disabled or
failed.
Fast Blinking (On 50ms,
Off 50ms)
The Locator LED is on.
Red On There is system error and the Zyxel Device cannot boot
up, or the Zyxel Device suffered a system failure.
Fast Blinking (On for
50ms, Off for 50ms)
The Zyxel Device is doing firmware upgrade.
Slow Blinking (Blink for 3
times, Off for 3s)
The Uplink interface is down.
Slow Blinking (Blink for 2
times, Off for 3s)
The Zyxel Device is managed by an AC and the uplink is
disconnected.
Management Green On The Zyxel Device is managed by a controller.
Slow Blinking (Blink for 3
times, Off for 3s)
The Zyxel Device is searching (discovery) for a controller.
Slow Blinking (On for 1s,
Off for 1s)
The Zyxel Device is using default WiFi settings, or the Zyxel
Device is connected to the NCC but is unregistered with
the NCC.
Off The Zyxel Device is in standalone mode.
To Next Page
Loading...
