Chapter 12 Remote Management
NWA1100-N User’s Guide
106
12.7 The SNMP Screen
Use this screen to have a manager station administrate your NWA over the network. To change
your NWA’s SNMP settings, click REMOTE MGMT > SNMP. The following screen displays.
Figure 55 Remote Management: SNMP
The following table describes the labels in this screen.
Table 35 Remote Management: SNMP
LABEL DESCRIPTION
SNMP Configuration
Get Community Enter the Get Community, which is the password for the incoming Get and GetNext
requests from the management station.
Set Community Enter the Set community, which is the password for incoming Set requests from the
management station.
Trap Destination Type the IP address of the station to send your SNMP traps to.
Trap Community Type the trap community, which is the password sent with each trap to the SNMP
manager.
This field is available only when SNMPv1 or SNMPv2 is selected in the SNMP Version
field.
Configure SNMPv3
User Profile
Click this to configure administration and user login details.
Enable
SNMPv3Admin
Select the check box to enable the SNMP administrator account for authentication with
SNMP managers using SNMP v3.
User Name Specify the user name of the SNMP administrator account.
Password Enter the password for SNMP administrator authentication.
Confirm Password Retype the password for confirmation.
To Next Page
Loading...
