Chapter 13 System
NWA / WAC Series User’s Guide
156
1 Launch the SSH client and specify the connection information (IP address, port number) for the NWA/
WAC.
2 Configure the SSH client to accept connection using SSH version 1.
3 A window displays prompting you to store the host key in you computer. Click Yes to continue.
Figure 95 SSH Example 1: Store Host Key
Enter the password to log in to the NWA/WAC. The CLI screen displays next.
13.5.5.2 Example 2: Linux
This section describes how to access the NWA/WAC using the OpenSSH client program that comes with
most Linux distributions.
1 Test whether the SSH service is available on the NWA/WAC.
Enter “telnet 192.168.1.2 22” at a terminal prompt and press [ENTER]. The computer attempts to
connect to port 22 on the NWA/WAC (using the default IP address of 192.168.1.2).
A message displays indicating the SSH protocol version supported by the NWA/WAC.
Figure 96 SSH Example 2: Test
2 Enter “ssh –1 192.168.1.2”. This command forces your computer to connect to the NWA/WAC using
SSH version 1. If this is the first time you are connecting to the NWA/WAC using SSH, a message displays
prompting you to save the host information of the NWA/WAC. Type “yes” and press [ENTER].
Then enter the password to log in to the NWA/WAC.
Figure 97 SSH Example 2: Log in
$ telnet 192.168.1.2 22
Trying 192.168.1.2...
Connected to 192.168.1.2.
Escape character is '^]'.
SSH-1.5-1.0.0
$ ssh –1 192.168.1.2
The authenticity of host '192.168.1.2 (192.168.1.2)' can't be established.
RSA1 key fingerprint is 21:6c:07:25:7e:f4:75:80:ec:af:bd:d4:3d:80:53:d1.
Are you sure you want to continue connecting (yes/no)? yes
Warning: Permanently added '192.168.1.2' (RSA1) to the list of known hosts.
Administrator@192.168.1.2's password:
To Next Page
Loading...
