Chapter 13 System
NWA / WAC Series User’s Guide
157
3 The CLI screen displays next.
13.6 Telnet
You can use Telnet to access the NWA/WAC’s command line interface. Click Configuration > System >
TELNET to configure your NWA/WAC for remote Telnet access. Use this screen to enable or disable Telnet
and set the server port number.
Figure 98 Configuration > System > TELNET
The following table describes the labels in this screen.
13.7 FTP
You can upload and download the NWA/WAC’s firmware and configuration files using FTP. To use this
feature, your computer must have an FTP client. See Chapter 15 on page 176 for more information
about firmware and configuration files.
To change your NWA/WAC’s FTP settings, click Configuration > System > FTP tab. The screen appears as
shown. Use this screen to specify FTP settings.
Table 69 Configuration > System > TELNET
LABEL DESCRIPTION
Enable Select the check box to allow or disallow the computer with the IP address that matches the IP
address(es) in the Service Control table to access the NWA/WAC CLI using this service.
Server Port You may change the server port number for a service if needed, however you must use the
same port number in order to use that service for remote management.
Apply Click Apply to save your changes back to the NWA/WAC.
Reset Click Reset to return the screen to its last-saved settings.
To Next Page
Loading...
