ZyXEL Communications NWA1123ACPRO-EU0101F - Chapter 17 Leds; Leds; Overview; Suppression Screen

NWA / WAC Series User’s Guide
189
CHAPTER 17
LEDs
17.1 Overview
The LEDs of your NWA/WAC can be controlled such that they stay lit (ON) or OFF after the NWA/WAC is
ready. There are two features that control the LEDs of your NWA/WAC - Locator and Suppression.
17.1.1 What You Can Do in this Chapter
• The Suppression screen (Section 17.2 on page 189)) allows you to set how you want the LEDs to
behave after the device is ready.
• The Locator screen (Section 17.3 on page 190) allows users to see the actual location of the NWA/
WAC between several devices in the network.
17.2 Suppression Screen
The LED Suppression feature allows you to control how the LEDs of your NWA/WAC behave after it’s
ready. The default LED suppression setting of your AP is different depending on your NWA/WAC model.
You can go to the Maintenance > LEDs > Suppression screen to see the default LED behavior and
change the LED suppression setting. After you make changes in the suppression screen, it will be stored
as the default when the NWA/WAC is restarted. See (Section 1.6 on page 20) for information on default
values for different models.
Note: When the NWA/WAC is booting or performing firmware upgrade, the LEDs will lit regardless of
the setting in LED suppression.
To access this screen, click Maintenance > LEDs > Suppression.