ZyXEL Communications Prestige 791R - Reset Button; Power Port; Turning on Your Prestige

Prestige 791R G.SHDSL Router
2-4 Hardware Installation
2.3.4 Reset Button
The Prestige comes with a reset button built into the rear panel. Use this button to restore the factory default
password to 1234, IP address to 192.168.1.1, subnet mask to 255.255.255.0 and DHCP server enabled with
a pool of 32 IP addressed starting at 192.168.1.33.
Hold this button in for between 1 and 3 seconds to restart the Prestige. Upload the default configuration file
by holding this button in for more than 3 seconds. Refer to section 3.2 for information on the resetting your
Prestige.
2.3.5 Power Port
Connect the power adapter to the port labeled POWER on the rear panel of your Prestige. Push in the
power button when you want to turn on the Prestige.
To avoid damage to the Prestige, make sure you use the supplied power adapter.
Refer to the Power Adapter Specification Appendix for this information.
2.4 Turning On Your Prestige
You can now turn on your Prestige by pushing in the power button (located on the back panel) to turn on
your Prestige.