ZyXEL Communications Prestige 791R - My WAN Addr Sample IP Addresses; Remote Node Filter; Figure 8-4 Sample IP Addresses for a TCP;IP LAN-To-LAN Connection

Prestige 791R G.SHDSL Router
8-8 Remote Node TCP/IP Configuration
8.3.1 My WAN Addr Sample IP Addresses
The following diagram explains the sample IP addresses to help you understand the field of My Wan Addr
in Menu 11.3. My WAN Addr indicates the local Prestige WAN IP while Rem IP Addr indicates the peer
WAN IP.
Figure 8-4 Sample IP Addresses for a TCP/IP LAN-to-LAN Connection
8.4 Remote Node Filter
Move the cursor to the Edit Filter Sets field in menu 11.1, then press [SPACE BAR] to select Yes. Press
[ENTER] to display Menu 11.5 – Remote Node Filter.
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between this remote node and the Prestige and also to prevent certain packets from triggering calls.
You can specify up to 4 filter sets separated by comma, for example, 1, 5, 9, 12, in each filter field.
Note that spaces are accepted in this field. The Prestige has prepackaged filter sets; refer to the chapter on
Filter Configuration for details. Include these in the call filter sets if you want to prevent NetBIOS packets
from triggering calls to a remote node.