How to Configure NAT Default Server
This example shows how to create Default Server on the VPN2S. The example
instructs how to configure the Default Server. When the Default Server is
configured, each Internet PC can be accessed Web Server.
Figure Default Server
Note:
1. Enter IP address and click "OK" to activate the default server.
2. The Interface Group for the default server is by default on firewall "LAN" zone. Use LAN to
configure it to other zone, if desired.
3. Some default ports of services are already used by device service. If you need the same
ports for the default server, please change the ports used by device service from Firewall /
Security > Device Service.
To Next Page
Loading...
