Chapter 7 Web Interface Tutorials – Multy M1 (WSM20)
Multy WiFi System User’s Guide
156
7.5 Configure Guest WiFi Networks
After the Multy Device is set up, you can use separate WiFi networks for your clients. The WiFi settings will
be applied to all clients in the same network.
Note: This is not available if you are using bridge mode.
1 Click the Navigation Panel icon on the top-left corner ( ), and click Settings > WiFi > Guest WiFi to
open the Guest WiFi screen.
2 Select Enable Guest WiFi and enter the WiFi Name (SSID) and WiFi Password. Click Apply to save your
changes.
To Next Page
Loading...
