ZyXEL Communications XGS4600 Series - Test the Result

102/215
www.zyxel.com
3.2.2 Test the Result
1 Verify the status of Switch-1: Go to Menu > Advanced
Application > Spanning Tree Protocol. The Root Bridge ID and
the Our Bridge ID should be the same. This means that Switch-1
is the Root Bridge. Both port 1 and 2 should be in FORWARDING
state, while both their Port Roles are Designated Ports.
2 Verify the status of Switch-2: Go to Menu > Advanced
Application > Spanning Tree Protocol. Check the port status of
Switch-2. Port 1 should be the Root Port in FORWARDING state,
while port 2 should be a Designated Port also in FORWARDING
state.