ZyXEL Communications XGS4600 Series - Configuration in the Switch

176/215
www.zyxel.com
5.7.1 Configuration in the Switch
1 Access the Switch’s Web GUI.
2 Configure DHCP Snooping (Refer to section 5.6.1).
3 Go to Advance Application > IP Source Guard > IPv4 Source
Guard Setup > ARP Inspection > Configure. Check the Active
box to globally enable ARP Inspection.
4 Go to Advance Application > IP Source Guard > IPv4 Source
Guard Setup > ARP Inspection > Configure > Port. Set all
access ports as untrusted ports. Ports to the USG or other
network components should be trusted ports. Click Apply.
Note:
DHCP Snooping must be enabled before configuring ARP Inspection.