ZyXEL Communications XGS4600 Series - Designing the Local Area Network; How to Configure the Switch to Separate Traffic between Departments Using VLAN

65/215
www.zyxel.com
Designing the Local Area Network
2.1 How to configure the switch to separate traffic between
departments using VLAN
The example shows administrators how to set up the switch to make
separate traffic between departments. Using Static VLAN, hosts
accessing the same VLAN will only be able to communicate with hosts
accessing the same VLAN.
Set up VLAN to separate the traffic between departments
Note:
All network IP addresses and subnet masks are used as examples in this article.
Please replace them with your actual network IP addresses and subnet masks. This
example was tested using XGS4600-32 (Firmware Version: V4.50).