ZyXEL Communications XGS4600 Series - Configuration in the Switch

187/215
www.zyxel.com
5.9.1 Configuration in the Switch
1 Access the Switch’s Web GUI.
2 Configure ARP Inspection (Refer to section 5.7.1).
3 Go to Advance Application > IP Source Guard > IPv4 Source
Guard Setup > Static Binding. Create a Static Binding entry
using your device’s MAC address and IP address. Input the
VLAN and port that this device is allowed unrestricted access.
Click Add.
Note:
DHCP Snooping and ARP Inspection must be enabled when applying
Static Binding.