93/215
3 Connect Switch-1 and Switch-2 together on port 32 using a
10-Gigabit transceiver.
4 Switch-1 and Switch-2 becomes a stacked switch. The Stack ID
LED on the front panel of the switches should display “1” and
“2”.
5 Remember to save the configuration.
Note:
The last two ports are usually reserved for stacking channels when
the switch is in stacking mode. These are ports 31 and 32 for the
XGS4600-32 switch. If you are using other stackable models, please
refer to the user manual to confirm the ports used for stacking.
To Next Page
Loading...
