ZyXEL Communications XS3700 Series - LLDP Configuration Basic TLV Setting

Chapter 35 Link Layer Discovery Protocol (LLDP)
XS3700 Series User’s Guide
297
35.6.1 LLDP Configuration Basic TLV Setting
Use this screen to configure Basic TLV settings. Click Advanced Application > LLDP > LLDP
Configuration > Basic TLV Setting to display the screen as shown next.
Figure 192 Advanced Application > LLDP > LLDP Configuration> Basic TLV Setting
The following table describes the labels in this screen.
Admin Status Select whether LLDP transmission and/or reception is allowed on this port.
• Disable - not allowed
• Tx-Only - transmit only
• Rx-Only - receive only
• Tx-Rx - transmit and receive
Notification Select whether LLDP notification is enabled on this port.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to begin configuring this screen afresh.
Table 157 Advanced Application > LLDP > LLDP Configuration
LABEL DESCRIPTION
Table 158 Advanced Application > LLDP > LLDP Configuration > Basic TLV Setting
LABEL DESCRIPTION
Port This displays the port number on which you’re configuring LLDP. Select check boxes in
the * row to configure all ports simultaneously. All check boxes below * row are enabled
by default.
Management
Address
Select check box to enable or disable the sending of Management Address TLVs on the
port(s).
Port Description Select check box to enable or disable the sending of Port Description TLVs on the port(s).
System
Capabilities
Select check box to enable or disable the sending of System Capabilities TLVs on the
port(s).
System
Description
Select check box to enable or disable the sending of System Description TLVs on the
port(s).
System Name Select check box to enable or disable the sending of System Name TLVs on the port(s).