Chapter 7 VLAN
XS3700 Series User’s Guide
83
Figure 43 Port VLAN Trunking
7.2.4 Select the VLAN Type
Select a VLAN type in the Basic Setting > Switch Setup screen.
Figure 44 Switch Setup: Select VLAN Type
7.2.5 802.1Q Static VLAN
Make sure 802.1Q is selected in the Basic Setting > Switch Setup screen.
Use a static VLAN to decide whether an incoming frame on a port should be
• sent to a VLAN group as normal depending on its VLAN tag.
• sent to a group whether it has a VLAN tag or not.
• blocked from a VLAN group regardless of its VLAN tag.
You can also tag all outgoing frames (that were previously untagged) from a port with the specified
VID.
7.3 VLAN Status
See Section 7.2 on page 80 for more information on 802.1Q VLAN. Click Advanced Application >
VLAN from the navigation panel to display the VLAN Status screen as shown next.
To Next Page
Loading...
