Chapter 43 Access Control
XS3700 Series User’s Guide
365
Figure 252 Management > Access Control > SNMP
The following table describes the labels in this screen.
Table 201 Management > Access Control > SNMP
LABEL DESCRIPTION
General Setting Use this section to specify the SNMP version and community (password) values.
Version Select the SNMP version for the Switch. The SNMP version on the Switch must match the
version on the SNMP manager. Choose SNMP version 2c (v2c), SNMP version 3 (v3) or
both (v3v2c).
Note: SNMP version 2c is backwards compatible with SNMP version 1.
Get Community Enter the Get Community string, which is the password for the incoming Get- and
GetNext- requests from the management station.
The Get Community string is only used by SNMP managers using SNMP version 2c or
lower.
Set Community Enter the Set Community string, which is the password for the incoming Set- requests
from the management station.
The Set Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Community Enter the Trap Community string, which is the password sent with each trap to the
SNMP manager.
The Trap Community string is only used by SNMP managers using SNMP version 2c or
lower.
Trap Destination Use this section to configure where to send SNMP traps from the Switch.
Version Specify the version of the SNMP trap messages.
IP Enter the IP addresses of up to four managers to send your SNMP traps to.
Port Enter the port number upon which the manager listens for SNMP traps.
Username Enter the username to be sent to the SNMP manager along with the SNMP v3 trap.
Note: This username must match an existing account on the Switch (configured in the
Management > Access Control > SNMP > User screen).
To Next Page
Loading...
