30
Note:
Do not apply control solution to the test strip directly from
the bottle.
5. Immediately touch the tip of the test strip to the drop of
control solution. The control solution is pulled into the test
strip through the strip tip.
Note:
If the control solution sample does not fill the check window,
do not add a second drop. Discard the test strip and start over
with a new test strip.
6. Hold it in the drop until the meter beeps, and then you see
the meter count down on the screen and followed with your
control test result after a beep.
Note:
The meter will automatically recognize and mark the control
result for you. Control results are not included in the 7, 14 and
To Next Page
Loading...
