21
Routing table enable Function No.: 20
Enable the use of the routing table with this parameter. Disabling this parameter
you put the table out of use.
Setting options: YES/NO
Default setting: NO
Prefix Function No.: -
A prefix identifying the call type (GSM, trunk call, free call, etc.). "Other numbers"
line is used for calls with prefixes that are not included in the table.
Setting options: 0-14 characters (0-9,*,#)
Default setting: blank
Call enable Function No.: -
This parameter allows/bars calls with prefixes included on the same line.
Setting options: YES/NO
Default setting: YES
Number length Function No.: -
The parameter defines the expected length of a number with a prefix included on
the same line. This enables to start dialing into a GSM network immediately after
the last digit is dialed. If the telephone number to be dialed is shorter, a timeout is
respected. The "0" setting means that the function is disabled.
Setting options: 0, 3-15
Setting step: 1
Default setting: 0
End with # Function No.: -
This parameter enables to establish the call when a # is received. The #
character is removed from the dialed number. If a # should be part of the dialed
number, this function cannot be used for the given prefix.
Setting options: YES/NO
Default setting: NO
Remove Function No.: -
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0
Add Function No.: -
The Add parameter is used for automatic call routing. A defined string (prefix) is
added to the beginning of the number to be dialed.
Setting options: 0-8 characters (0-9,*,#,+)
Default setting: blank
To Next Page
Loading...
