2N® Indoor View User Manual
•
•
•
•
•
•
•
•
•
•
•
•
•
Call Answering Mode (SIP 1, SIP 2) – set the way of receiving incoming calls. The
following three options are available:
Always busy–the device rejects incoming calls.
Manual answering– the device rings to signal incoming calls and the user can press
a keypad button to pick up.
Automatic– the device picks up incoming calls automatically. You can set the call
receiving mode for each SIP account separately.
Local Call Receiving Mode – set the way of receiving incoming local calls.
Always busy–the device rejects incoming calls.
Manual answering– the device rings to signal incoming calls and the user can press
a keypad button to pick up.
Automatic– the device picks up incoming calls automatically. You can set the call
receiving mode for each SIP account separately.
Voicemail Mode – apre-defined voice message (as set in the User Sounds) is played into
the call after a timeout defined in the Pick Up in parameter in the automatic / manual call
answering mode if the Only out-of-office message is set. A beep is also played in the
Video Voicemail and an up to 20 seconds long call recording starts (audio and video if
available) for the calling user to leave a message. If no user message is recorded, a default
voice message in one of the seven available languages (as set in the Voice message
language) can be used.
Pick Up in – this parameter is only active when the Automatic pickup mode is enabled.
The call is picked up automatically after the preset timeout.
Reject Calls in DND Mode – if this function is activated, the device reject calls in the Do
not Disturb mode. The function can be used for immediate call redirection at absence to a
mobile phone call, for example.
DND Mode for Doorbell Button – if this function is activated, the device shall not ring
when the doorbell button is pressed.
Do Not Disturb Mode with Time Profile –hoose one or more time profiles to be applied.
Set the time profiles in Directory / Time profiles.
To Next Page
Loading...
