Block Parameter Settings
Select the required Event (Event.xxx), Action (Action.xxx) or Condition (Condition.
xxx) in the column. Set one or more parameters for the blocks in the Object type
respective row of the column – refer to the block describing subsections Parameters
below for the supported parameters. Enter the block parameter value into the
appropriate field below the parameter name.
The changes will not be executed until you press the button in the right-hand Save
upper corner of the page .
Click Save to save the changes. If the function setting is correct, the information is
displayed in a green field. If incorrect (invalid name/value or missing mandatory
parameter), error information is displayed in a red field. Wrong values are marked with
and the parameter name is red. works only if all the available blocks Automation
are configured properly. If not, is in the Error state.Automation
Most of the blocks include parameters (Event, Condition, StartEvent, e.g.) that refer to
other blocks. To interconnect the blocks, click on the output of one block and drag
and drop it to the input of another.
Tip
The Upper-Lower case need not be respected in the parameter names.
Some block parameters are optional. If you do not enter an optional
parameter in the block definition, the default value will be applied.
To Next Page
Loading...
Need help?
General
