Installation manual 2N® IP Solo
•
•
•
•
•
•
•
•
•
Caution
Before starting the mechanical installation on a selected place, make sure
carefully that the preparations connected with it (drilling, wall cutting) cannot
damage the electrical, gas, water and other existing wires and pipes.
Make sure that the diameter of the dowel holes is accurate to avoid falling out of
the dowels! Use the mounting glue to secure the dowels if necessary.
Make sure that the depth of the dowel holes is accurate!
Do not use low-quality dowels to avoid their pulling out of the wall!
Having removed the front panel, make sure that no dirt gets inside the product
(especially onto the sealing surface).
Never turn 2N
®
IP Solo to align the box assembly after mounting. Make sure that
the flush mounting boxes have been installed accurately.
Check the plasterboard wall and room interior pressure values. If the difference
between the values is too great (as a result, e.g., of overpressure ventilation),
separate the intercom using, for example, the mounting box enclosed and seal the
cable passage to avoid speaker damage.
Surface mounting may cause problems on places exposed to potential vandalism
(such as public garages, etc.). In this case, use steel anchoring elments instead of
the dowels and screws included in the delivery.
The place for surface mounting must be flat with maximum inequality of 0.5 mm.
(e.g. desk materials, glass, cutted stone etc). If the place is not flat, use flush
mounting, backplate Part No. 9155068 or equal the wall surface.
To Next Page
Loading...
