2N IP Solo - Door Opening Procedure; Maintenance; Cleaning Guidelines; Cleaning Warnings

Installation manual 2N® IP Solo
61 / 74
•
•
•
•
•
•
Procedure:
Enter the switch 1 or 2 activating code using your phone keypad and press for
confirmation. Confirmation is unnecessary if theLock code without confirmationis
enabled,refer to theIntercom Configuration / Hardware / Switches / Advanced
subsection of Configuration Manual.
A valid code is signalled by the sound. An invalid codeor interruption longer than as
defined inTimeout for Entering Numbersis signalled by the sound.
3.4 Maintenance
Cleaning
If used frequenly, the device surface, the keypad in particular, gets dirty.To clean it, use a piece
of soft cloth moistened with clean water. We recommend you to follow these principles while
cleaning:
Never use aggressive detergents (such as abrasives or strong disinfectants).
Use suitable cleaning agents for glass lens cleaning (cleaners for glasses, optic devices
screens, etc.)
Clean the device in dry weather in order to make waste water evaporate quickly.
The electronics cleaning wipes are suitable.
•
Anticovid
To keep your equipment surfaces clear of bacteria and viruses (Anti-Covid
disinfection) and maintain the hygienic conditions of critical surfaces and touch
points we recommend that you use the Zoono – Microbe Shield Surface Sanitiser
Spray.

•
•
•
Warning
Prevent water from getting inside the intercom.
Do not use alcohol-based cleaners.
Avoid peroxide-based cleaners.
