2N IP Solo - Electric Installation; Mounting Preparation; Power Supply Connection

Installation manual 2N® IP Solo
38 / 74
1.
2.
2.3 Electric Installation
This subsection describes how to install the modules, how to connect the2N
®
IP Solomain unit
to the power supply and LAN and how to connect other elements.
Mounting Preparation
Place the2N
®
IP Solo on the flush mounting box / pre-drilled holes with dowels and pull
the cables through the bottom holes. Pull the Ethernet cable through the bottom hole to
the left if necessary.
Insert the metal fitting elements up and down and screw the access unit tight. You can
level the unit slightly in this mounting type.
Main Unit
Power Supply Connection
2N
®
IP Solocan be powered either from an external 12 V / 2 A DC source or directly from the LAN
equipped with PoE 802.3af supporting network elements.
External power supply
Use a 12 V ±15 %SELV supply dimensioned to the minimum current consumption of 2 A (Part
No. 91341481E) to make your system work reliably.
•
Caution
The device must be part of the electrical system of the building.
