2N IP Solo - Extending Module Connection; Security Relay Module

Installation manual 2N® IP Solo
51 / 74
•
•
•
2.4 Extending Module Connection
2N
®
IP Soloallows to connect the following extending modules:
Security relay
Security Relay
The2N
®
IPSecurity Relay(Part No.9159010) is used for enhancing security between the
intercom and the connected electric lock.The2N
®
IP Intercom Security Relayis designed for
any2N IPintercommodel withfirmware versions 1.15 and higher. It significantly enhances
security of the connected electriclock as it prevents lock opening by forced intercom tampering.
Function:
The2N
®
IP Intercom Security Relayis a device installed between an intercom (outside the
securedarea) and the electric lock (inside the secured area). The2N
®
IP Intercom Security
Relayincludesa relay that can only be activated if the valid opening code is received from the
intercom.
Specifications:
Passive switch: NO and NC contacts, up to 30 V / 1 A AC/DC
Switched output:
Where the security relay is fed from the intercom, 9 to 13 V DC is available on the output
depending on the power supply (PoE: 9 V; adapter: source voltage of minus 1 V) / 400 mA
DC.
Where the security relay is fed from an external power supply, 12 V / 700 mA DC is available
on the output.
Dimensions: (56 x 31 x 24) mm
Weight: 20 g