2N IP Solo - Function and Use; Configuration

Installation manual 2N® IP Solo
57 / 74
•
•
•
•
•
•
•
•
3. Function and Use
This section describes the basic and extending functions of thethe2N
®
IP Solo product.
Here is what you can find in this section:
3.1 Configuration
3.2 Intercom Control as Viewed by External User
3.3 Intercom Control as Viewed by Internal User
3.4 Maintenance
3.5 Downloads
3.1 Configuration
Configure2N
®
IP Solousing yourPC with anyinternet browser:
Launch your internet browser (Internet Explorer, Firefox, etc.).
Enter the IP address of your intercom (http://192.168.1.100/, e.g.).
Log in using the usernameAdminand password2n.
You have to know your intercom IP address to log in to the integrated web server. Upon
purchase,2N
®
IP Solois set to the dynamic IP address mode – it retrieves the IP address
automatically if there is a properly configured DHCP server in the LAN. If no DHCP is available,
operate2N
®
IP Soloin the static IP address mode. Refer to the Configuration manual for 2N IP
intercomsfor the2N
®
IP Soloconfiguration details.
If your device remains inaccessible (you have forgotten the IP address, the network
configuration has changed, etc.), you can change the network configuration using the device
buttons.