2N IP Solo - IP Address Management; IP Address Finding; Static IP Configuration

Installation manual 2N® IP Solo
44 / 74
•
•
•
•
•
•
Reset Button
Located among the main unit connectors, the Reset button helps you reset the factory default
values, restart the device, find the device IP address and switch the static/dynamic mode.

IP Address Finding
Follow the instructions below toidentify thecurrent IP address:
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
Release the RESET button.
The device automatically announces the current IP address.
Static IP Address Setting
Follow the instructions below to switch on theStatic IP addressmode (DHCP OFF):
Press and hold the RESET button.
Wait until the red and green LEDs go on simultaneously on the device and the acoustic
signal can be heard (approx. 15–35 s).
•
•
Note
The delay after pressing RESET till the first light and sound signalling is set to 15–
35 s depending on the 2N IP intercom/answering unit model used.
18 s is the valid value for 2N
®
IP Solo.
