Installation manual 2N® IP Solo
•
1.
2.
3.
4.
5.
•
•
Nametag Placing
Every intercom package includes a piece of transparent foil, which can be laser printed. Cut the
printed foil and insert the nametags in the buttons.
Nametag dimensions for button:
1 button: 52.0 (W) x 15.2 (H) mm (dimensional tolerance: +0; -0.5 mm)
Nametag inserting/replacing:
Remove the frame.
Lift up the button door. The 5-button module buttons have just one door.
Remove the used nametag and insert a new one.
Close the button door.
Replace the frame.
Frame Replacement
Check the frame sealing before replacing the frame.
Version A
Screw the flush mounting frame in the upper and bottom parts.
Version B
Hang the surface mounting frame on the hook in the upper part and then screw it tight in
the bottom part.
•
•
Caution
The area where nametags are placed is called a wet zone. After heavy rain, water
can penetrate to the nametag. Water in this area does not affect the intercom
functionality in any way and evaporates soon.
Always use waterproof foil (enclosed or other) for the nametags. Never use paper
or ink jet printing to avoid damage due to water leakage!
To Next Page
Loading...
