2N IP Style User Manual

2N TELEKOMUNIKACE a.s., www.2n.cz 69/105
Caution
supports connection of just one Bluetooth module. If 2N IP Style
®
connected, multiple Bluetooth modules may result in a undesired
behavior.
Induction Loop Module
The Induction loop module ( ) is one of the 2N IP Verso system Part No. 9155041
®
elements and is used form transmitting audio signals directly into a hearing aid via a
magnetic field.
The module contains two bus connectors.2N IP Style
®
These two connectors are fully interchangeable and can be used either as inputs
from the basic unit or outputs to other modules.
If this module is the last one on the bus, one of the connectors remains
unconnected.
The module package includes a 220 mm long interconnecting cable.
Used mode: T
Maximum power: 2 W
Frequency range: 100 Hz – 5 kHz / ± 3 dB
External antenna ( ) connection optionPart No. 9155043
Antenna output short circuit resistance: without limitation
Fingerprint Scanner Module
The Fingerprint scanner ( ) is one of the 2N IP Verso system Part No. 9155045
®
elements and is used for verification of human fingerprints for access control and
intercom / third party equipment control.
The module contains two bus connectors.2N IP Style
®
These two connectors are fully interchangeable and can be used either as inputs
from the basic unit or outputs to other modules.
If this module is the last one on the bus, one of the connectors remains
unconnected.
The module package includes a 220 mm long interconnecting cable.

2N IP Style Specifications

General

Tamper Switch	Yes
Power Supply	12V DC
Ingress Protection	IP65
Inputs	2
Operating Voltage	12V DC
Speaker Impedance	8 Ohm