3.3 Intercom Control as Viewed by Internal
User
Call Answering
You can answer incoming calls from using your phone like any other calls. 2N IP Style
®
You can unlock the door, activate/deactivate a user/profile via your phone keypad
during the call. The calls, however, are time-limited to avoid unintentional blocking of
the line. Set the maximum call duration in the Call time limit parameter 2N IP Style
®
(refer to Subs. of the Configuration Manual). Press # on your phone Phone / Calls
anytime to extend the call time. The automatic call termination is signaled with a short
beep 10 s before the call end.
Calling to 2N ® IP Style
2N IP Style
®
allows you to answer incoming calls. Set the required parameters in the
Incoming calls group (refer to Subs. of the Configuration Manual).Phone / Calls
Door Opening (Switch Activation) by Code
2N IP Style
®
is equipped with a door unlocking switch. Enter the valid code (refer to
Subs. of the Configuration Manual) using your phone keypad to Hardware / Switches
activate this switch.
Procedure:
Enter the switch 1 or 2 activating code using your phone keypad and press
for confirmation. (Confirmation is unnecessary if the Lock code without
confirmation is enabled, refer to the Hardware / Switches / Advanced
subsection).
A valid code is signaled acoustically . An invalid code or interruption longer
than as defined in is signaled acoustically , Timeout for Entering Numbers
.
To Next Page
Loading...
