38 CHAPTER 4: NBX MESSAGING
Forwarding a
Message
You can forward most messages, with or without comments.
If you receive a message that is marked Private, you cannot forward it.
To forward a message:
1 Log in to your voice mailbox at your telephone or remotely.
2 Listen to a message that you want to forward, and press 5.
3 After the tone, record an introductory message and then press # OR if
you choose not to record a comment, press # when you hear the tone.
4 Optionally, press one of these buttons, OR proceed to step 5.
5 When you are ready to forward the message, press 1.
6 Dial one of these destination numbers plus #:
■ The internal extension or mailbox number of the recipient
■ A speed dial number. See “Speed Dials” in Chapter 6.
■ A voice mail group list number. (See “Using Voice Mail Group Lists”
later in this chapter.)
■ A site code plus extension (to send to a user on another NBX system in
your organization). Example: neee or neeee (where n = one or more
site code digits and e = the extension digits on the other system).
For valid site codes in your organization, see your administrator.
7 To forward the message to several recipients, dial each destination
number followed by #.
8 After the last destination number and its #, press # again to send your
message.
9 Follow the prompts to delete or save the message you just forwarded.
Re-record your introductory comment.
Listen to your introductory comment.
Mark the message Private or Urgent. See “Marking a
Message as Private or Urgent” later in this chapter.
Cancel your message.
To Next Page
Loading...