76 CHAPTER 6: PERSONALIZING YOUR TELEPHONE
Using a Headset You can use a headset that has a microphone with any telephone on an
NBX system.
■ For how to use a typical headset and amplifier with 3Com Telephones
other than the 3Com Manager’s Telephone or 3102 Business
Telephone, see “General Headset Instructions”
later in this section.
■ For how to connect and use a headset with the 3Com Manager’s
Telephone and 3102 Business Telephone, read the next section.
With the 3Com
Manager’s Telephone
and 3Com 3102
Business Telephone
The 3Com Manager’s Telephone and 3Com 3102 Business Telephone
have a headset jack located on the underside of the telephone on the left
side.
To prepare the headset for all calls on the 3Com Manager’s Telephone
and 3102 Business Telephone:
1 Plug the headset connector into the headset jack on the underside of the
telephone. See Figure 12
in Appendix A for the location of the jack.
2 Press the Headset button. By default, this is the Access button just below
the (Program) button at the top right corner of the telephone.
3 Verify that the indicator light beside the Headset button turns on.
To answer a call when you are using the headset:
1 Put the headset on. When a call comes in, press the System Appearance
button beside the flashing light. You are connected to the call.
The handset can be either on hook or off hook.
To end a call when you are using the headset, press the Release button
on the telephone. By default, the Release button is located at the
bottom of the right column of Access buttons.
To configure a 3102 Business Telephone to ring through the headset and
not on the telephone, set the ringer tone to Silent Ring. See “Ringer
Tones” on page 64.
General Headset
Instructions
For 3Com Telephones other than the 3Com Manager’s Telephone or
3102 Business Telephone, follow these instructions.
You may need to modify some of these instructions for some headsets or
amplifiers. See the instructions that come with your equipment.
To Next Page
Loading...