CLI Commands 97
Initialize
The Initialize command resets the device configuration
to factory defaults, retaining the current IP
configuration.
Syntax
Initialize
Default Configuration
This command has no default configuration.
User Guidelines
The system prompts for confirmation of the request. If
no response is entered within 15 seconds, timeout
occurs and the command is not executed.
Example
The following example resets the Switch to factory
defaults:
Reboot
The Reboot command simulates a power cycle of the
device.
Syntax
reboot
Default Configuration
This command has no default configuration.
User Guidelines
There are no user guidelines for this command.
Example
Select menu option: initialize
WARNING: This command initializes the system to
factory defaults (excluding Management IP
configuration) and causes a reset.
Do you wish to continue (yes,no)[no]: yes
Saving configuration.....Saved config to all
units.
System rebooting..........
Select menu option: reboot
Are you sure you want to reset the system
(yes,no)[no]: yes
Saving configuration......Saved config to all
units.
System rebooting..........
To Next Page
Loading...
Need help?
General