BPDU Tunnel Configuration Example 165
Configuration procedure
1 Configure Switch A
# Enable rapid spanning tree protocol (RSTP) on the device.
[Switch_A] stp enable
# Set the port Ethernet 0/1 as a trunk port and configure it to permit VLAN 10 to
pass through.
[Switch_A] vlan 10
[Switch_A- Ethernet 0/1] port link-type trunk
[Switch_A- Ethernet 0/1]port trunk permit vlan 10
2 Configure Switch B
# Enable RSTP on the device.
[Switch_B] stp enable
# Set the port Ethernet 0/1 as a trunk port and configure it to permit VLAN 10 to
pass through.
[Switch_B] vlan 10
[Switch_B- Ethernet 0/1] port link-type trunk
[Switch_B- Ethernet 0/1]port trunk permit vlan 10
3 Configure Switch C
# Enable multiple STP (MSTP) on the device.
[Switch_C] stp enable
# Enable BPDU Tunnel on the device.
[Switch_C] vlan-vpn tunnel
# Add the port Ethernet 4/1/1 into VLAN 20.
[Switch_C] vlan 20
[Switch_C-Vlan 20] port Ethernet 4/1/1
# First disable STP and then enable VLAN VPN on the port Ethernet 4/1/1.
[Switch_C] interface Ethernet 4/1/1
[Switch_C-Ethernet4/1/1] stp disable
[Switch_C-Ethernet4/1/1] vlan-vpn enable
# Set the port Ethernet 4/1/2 as a trunk port.
[Switch_C-Ethernet4/1/2] port link-type trunk
# Add the trunk port into all the VLANs.
[Switch_C-Ethernet4/1/2] port trunk permit vlan all
4 Configure Switch D
To Next Page
Loading...
