3Com 8807 - CCC MPLS L2 VPN Configuration

616 CHAPTER 51: MPLS VLL
n
You also can configure LSPs without P devices.
CCC MPLS L2VPN
Configuration
Configuring CCC MPLS
L2VPN
Kompella
Similar to Layer 3 BGP/MPLS VPN
defined in RFC2547.
PEs discover Layer 2 VPN nodes
automatically through IBGP sessions
established between them. They also
propagate the VPN information.
Labels are distributed in the form of
label blocks, which enables multiple
connections being assigned tags
simultaneously. The size of a tag block
is determined by CE Range
(user-configurable).
VPN-target is used to differentiate
VPNs.
Users can assign extra labels to VPNs for
future use. This eases the configuration
work loads of VPN deployment and
capacity expansion.
VPN-target is used to identify VPNs. This
brings great flexibility for VPN
networking.
Connections between CEs are not
concerned. This type of MPLS L2VPN is
implemented by dividing the entire SP
network into different VPNs and
numbering these CEs in the VPNs. To
establish a connection between two
CEs, you need to set the local CE ID and
the remote CE ID on the PE, and specify
the Circuit ID assigned for the
connection by the local CE.
Table 563 Features and implementation ways of the three types of MPLS L2VPNs
VPN type Implementation Feature
Tabl e 564 Configure CCC MPLS L2VPN
Operation Command Description
Enter system view system-view -
Configure LSR ID mpls lsr-id X.X.X.X Required
Enable MPLS mpls Required
Create the egress for the
static LSP
static-lsp egress lsp-name
l2vpn incoming-interface
vlan-interface vlan-id
in-label in-label
Required. Before configuring
a CCC connection, you need
to configure two static LSPs
between the two PEs and all P
routers in between for
bidirectional packets. Refer to
corresponding sections in the
command manual for more
information about these
commands and corresponding
undo commands.
Create the ingress for the
static LSP
static-lsp ingress lsp-name
l2vpn nexthop
next-hop-addr out-label
out-label
Create the transit for the
static LSP
static-lsp transit lsp-name
l2vpn incoming-interface
vlan-interface vlan-id
in-label in-label { nexthop
next-hop-addr |
out-interface vlan-interface
vlan-id } out-label out-label
Quit MPLS view and enter
system view
quit -
Enable MPLS L2VPN mpls l2vpn Required