660 CHAPTER 53: VRRP CONFIGURATION
You can enable VRRP debugging to check its running. You may choose to enable
VRRP packet debugging (option as packet), VRRP state debugging (option as
state), and/or VRRP error debugging (option as error). By default, VRRP debugging
is disabled.
VRRP Configuration
Example
VRRP Single Virtual
Router Example
Networking requirements
Host A uses the VRRP virtual router which combines switch A and switch B as its
default gateway to access host B on the Internet.
VRRP virtual router information includes: virtual router ID1, virtual IP address
202.38.160.111, switch A as the Master and switch B as the Backup allowed
preemption.
Display the configuration information of the
VRRP-enabled IFM device
display vrrp ifm
Display VRRP statistics information
display vrrp statistics [ vlan-interface
interface-number [ virtual-router-ID ]
Display VRRP summary information display vrrp summary
Clear the statistics information about VRRP
reset vrrp statistics [ vlan-interface
interface-number [ virtual-router-ID ] ]
Enable VRRP debugging. debugging vrrp { state | packet | error }
Disable VRRP debugging.
undo debugging vrrp { state | packet |
error }
Table 601 Display and debug VRRP
Operation Command
To Next Page
Loading...
