34 CHAPTER 3: LOGGING IN TO SWITCH
Figure 3 Configure the port for connection
Figure 4 Set communication parameters
Step 3: The switch is powered on. Display self-test information of the switch and
prompt you to press Enter to show the command line prompt such as <SW8800>.
Step 4: Input a command to configure the switch or view the operation state.
Input a "?" for help. For details of specific commands, refer to the following
chapters.
Setting up
Configuration
Environment through
Telnet
Connecting a PC to the
Switch through Telnet
After you have correctly configured IP address of a VLAN interface for a switch via
Console port (using ip address command in VLAN interface view), and added the
port (that connects to a terminal) to this VLAN (using port command in VLAN
view), you can telnet this switch and configure it.
To Next Page
Loading...
