3Com 8807 - User Interface Configuration

40 CHAPTER 4: USER INTERFACE CONFIGURATION
■ AUX user interface is numbered as the second interface designated as user
interface 1.
■ VTY is numbered after AUX user interface. The absolute number of the first
VTY is incremented by 1 than the AUX user interface number.
Relative number
The relative number is in the format of "user interface type" + "number". The
"number" refers to the internal number for each user interface type. This method
can only specify one interface or one group of interfaces for a user interface type
instead of different user interface types.
It follows the rules below:
■ Number of Console user interface: console 0.
■ Number of AUX user interface: AUX 0.
■ Number of VTY: The first VTY interface is designated as VTY 0; the second one
is designated as VTY 1, and so on.
User Interface
Configuration
The following sections describe the user interface configuration tasks.
■ “Entering User Interface View”
■ “Define the Login Header”
■ “Configuring Asynchronous Port Attributes”
■ “Configuring Terminal Attributes”
■ “Managing Users”
■ “Configuring Modem Attributes”
■ “Configuring Redirection”
Entering User Interface
View
The following command is used for entering a user interface view. You can enter a
single user interface view or multi user interface view to configure one or more
user interfaces respectively.
Perform the following configuration in system view.
Define the Login Header The following command is used for configuring the displayed header when user
login.
When the users log in to the switch, if a connection is activated, the login header
will be displayed. After the user successfully logs in the switch, the shell header
will be displayed.
Perform the following configuration in system view.
Tabl e 7 Enter user interface view
Operation Command
Enter a single user interface view or multi user
interface views
user-interface [ type ] first-number [
last-number ]