36
RECURSIVE ROUTING CONFIGURATION
Recursive Routing
Configuration
Recursive Routing
Overview
Every route entry must have its next hop address. For a common route, its next
hop address is within the network segment to which the router is directly
connected; for a route requiring recursion, its next hop address is not within the
network segment to which the router is directly connected. During route
forwarding, this non-directly connected next hop address must be
recursion-processed once or several times to find out a directly connected next
hop address to enable L2 path searching. A recursive route can be a static route or
BGP route. Recursive routing can make route entries flexible, independent of a
specific interface.
Configuring Recursive
Routing
Tab le 406 Configure recursive routing
Operation Command Description
Enter system view System-view -
Enable recursive routing route-rely [ bgp | static ]
By default, both routes
learned by the BGP and static
routes support recursive
routing.
To Next Page
Loading...
