3Com 8807 - Page 185

Introduction to QoS Configuration Based on Port Groups 185
Tab le 157 Configure QoS based on port groups
Configuration procedure Command Description
Enter system view system-view -
Enable descriptor share on the
specified card
share descriptors slotid
This function is disabled by
default.
Enter port group view port-group index
Required
index: Port group number.
The port group number of a
common interface card
ranges from 1 to 128.
Add a port to the port group port interface-list
Required
interface-list={ interface-type
interface-number [ to
interface-type
interface-number ] }&<1-n>
Display the configured
information of the port group
display port-group [ index ]
Optional
This command can be
executed in any view
Apply the flow template
flow-template
user-defined
Optional
See “Defining and Applying
Flow Template” “Defining
and Applying Flow Template”
Activate the ACL packet-filter inbound
Optional
See “Activating ACL”
“Activating ACL”
Configure local priority of the
port group
priority { priority-level | trust
}
Optional
See “Configuring Service
Parameter Allocation Rule”
“Configuring Service
Parameter Allocation Rule”
Configure traffic policing traffic-limit inbound
Optional
See “Configuring Traffic
Policing” “Configuring Traffic
Policing”
Configure traffic shaping
traffic-shape [ queue
queue-id ] max-rate burst-size
Optional
See “Configuring Traffic
Shaping” “Configuring Traffic
Shaping”
Configure packet priority traffic-priority inbound
Optional
See “Configuring Traffic
Priority” “Configuring Traffic
Priority”
Configure packet redirection traffic-redirect inbound
Optional
See “Configuring Traffic
Redirection” “Configuring
Traffic Redirection”
Configure queue scheduling
algorithm
queue-scheduler wrr {
group1 { queue-id
queue-weight } &<1-8> |
group2 { queue-id
queue-weight } &<1-8> }*
Optional
See “Configuring Queue
Scheduling” “Configuring
Queue Scheduling”