Command Line View 23
■ OSPF area view
■ BGP view
■ IS-IS view
■ Route policy view
■ Basic ACL view
■ Advanced ACL view
■ Layer-2 ACL view
■ Conform-level view
■ WRED index view
■ RADIUS server group view
■ ISP domain view
■ MPLS view
■ VPNv4 sub-address family view
■ VPN-instance sub-address family view
■ BGP-VPNv4 sub-address family view
■ MPLS L2VPN view
■ L2VPN address family view
■ Route-Policy view
■ vpn-instance view
■ OSPF protocol view
■ Remote-peer view
■ VSI-LDP view
■ VSI view
■ HWTACACS view
■ Port group view
The following table describes the function features of different views and the ways
to enter or quit. Port numbers are only for examples.
Tab le 2 Function feature of command view
Command
view
Function Prompt
Command to
enter
Command to
exit
User view
Show the basic
information
about operation
and statistics
<SW8800>
Enter right after
connecting the
switch
Use quit to end
the
disconnection
with the switch
System view
Configure system
parameters
[SW8800]
Key in
system-view in
user view
Use quit or
return to return
to user view
To Next Page
