388 CHAPTER 33: BGP CONFIGURATION
Configuration procedure
1 Configure Switch A:
[Switch A] interface Vlan-interface 2
[Switch A-Vlan-interface2] ip address 192.1.1.1 255.255.255.0
[Switch A] interface Vlan-interface 3
[Switch A-Vlan-interface3] ip address 193.1.1.1 255.255.255.0
# Enable BGP
[Switch A] bgp 100
# Specify the network that BGP sends to
[Switch A-bgp] network 1.0.0.0
# Configure the peers
[Switch A-bgp] group ex192 external
[Switch A-bgp] peer 192.1.1.2 group ex192 as-number 200
[Switch A-bgp] group ex193 external
[Switch A-bgp] peer 193.1.1.2 group ex193 as-number 200
[Switch A-bgp] quit
# Configure the MED attribute of Switch A
Add ACL on Switch A, enable network 1.0.0.0.
[Switch A] acl number 2000
[Switch A-acl-basic-2000] rule permit source 1.0.0.0 0.255.255.255
[Switch A-acl-basic-2000] rule deny source any
Define two route policies, one is called Apply_med_50 and the other is called
Apply_med_100. The first MED attribute with the route policy as network 1.0.0.0
is set as 50, while the MED attribute of the second is 100.
[Switch A] route-policy apply_med_50 permit node 10
[Switch A-route-policy] if-match acl 2000
[Switch A-route-policy] apply cost 50
[Switch A-route-policy] quit
[Switch A] route-policy apply_med_100 permit node 10
[Switch A-route-policy] if-match acl 2000
[Switch A-route-policy] apply cost 100
[Switch A-route-policy] quit
Apply route policy Apply_med_50 to egress route update of Switch C (193.1.1.2),
and apply route policy Apply_med_100 on the egress route of Switch B
(192.1.1.2)
[Switch A] bgp 100
[Switch A-bgp] peer ex193 route-policy apply_med_50 export
[Switch A-bgp] peer ex192 route-policy apply_med_100 export
2 Configure Switch B:
[Switch B] interface vlan-interface 2
[Switch B-Vlan-interface2] ip address 192.1.1.2 255.255.255.0
[Switch B] interface vlan-interface 4
To Next Page
Loading...
