EasyManua.ls Logo

3Com 8807 - Page 553

3Com 8807
883 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Typical BGP/MPLS VPN Configuration Example 553
[CE1-vlan201] quit
[CE1] interface Vlan-interface 201
[CE1-Vlan-interface201] ip address 168.1.1.1 255.255.0.0
[CE1-Vlan-interface201] quit
[CE1] bgp 65410
[CE1-bgp] group 168 external
[CE1-bgp] peer 168.1.1.2 group 168 as-number 100
[CE1-bgp] import-route direct
[CE1-bgp] import-route static
n
The configuration on the other three CE switches (CE2 to CE4) is similar to that on
CE1, the details are omitted here.
2 Configure PE1
# Configure vpn-instance for VPNA on PE1, as well as other associated attributes
to control advertisement of VPN routing information.
[PE1] ip vpn-instance vpna
[PE1-vpn-vpna] route-distinguisher 100:1
[PE1-vpn-vpna] vpn-target 111:1 both
[PE1-vpn-vpna] quit
# Configure PE1 and CE1 as MP-EBGP neighbors, import CE1 VPN routes learned
into MBGP VPN-instance address family.
[PE1] bgp 100
[PE1-bgp] ipv4-family vpn-instance vpna
[PE1-bgp-af-vpn-instance] import-route direct
[PE1-bgp-af-vpn-instance] group 168 external
[PE1-bgp-af-vpn-instance] peer 168.1.1.1 group 168 as-number 65410
[PE1-bgp-af- vpn-instance] quit
[PE1-bgp] quit
# Bind the VLAN interface connecting PE1 and CE1 to the VPNA. Note that you
should first configure association between the VLAN interface and VPN-instance,
and then configure the IP address of the VLAN interface.
[PE1] vlan 202
[PE1-vlan202] port gigabitethernet 2/1/2
[PE1-vlan202] quit
[PE1] interface Vlan-interface 202
[PE1-Vlan-interface202] ip binding vpn-instance vpna
[PE1-Vlan-interface202] ip address 168.1.1.2 255.255.0.0
[PE1-Vlan-interface202] quit
# Configure Loopback interface. (For PE, the IP address for Loopback interface
must be a host address with 32-bit mask, to prevent the route is aggregated and
then LSP cannot process correctly interior-layer labels.)
[PE1] interface loopback0
[PE1-LoopBack 0] ip address 202.100.1.1 255.255.255.255
[PE1-LoopBack 0] quit
# Configure MPLS basic capacity and enable MPLS and LDP on VLAN interface
connecting PE1 and P. Create LSP and achieve MPLS packet forwarding.

Table of Contents

Other manuals for 3Com 8807

Related product manuals