Typical BGP/MPLS VPN Configuration Example 577
[PE1] mpls lsr-id 172.1.1.2
[PE1-mpls] lsp-trigger all
[PE1-mpls] quit
[PE1] mpls ldp
[PE1-mpls-ldp] quit
[PE1] interface vlan 110
[PE1-Vlan-interface110] mpls
[PE1-Vlan-interface110] mpls ldp
[PE1-Vlan-interface110] quit
# Configure basic MPLS capability on ASBR-PE1, enable LDP on the interface
connected to PE1, and enable MPLS on the interface connected to ASBR-PE2.
[ASBR-PE1] mpls lsr-id 172.1.1.1
[ASBR-PE1-mpls] lsp-trigger all
[ASBR-PE1-mpls] quit
[ASBR-PE1] mpls ldp
[ASBR-PE1-mpls-ldp] quit
[ASBR-PE1] interface vlan 110
[ASBR-PE1-Vlan-interface110] mpls
[ASBR-PE1-Vlan-interface110] mpls ldp
[ASBR-PE1-Vlan-interface110] quit
[ASBR-PE1] interface vlan 210
[ASBR-PE1-Vlan-interface210] mpls
[ASBR-PE1-Vlan-interface210] quit
# Configure basic MPLS capability on ASBR-PE2, enable LDP on the interface
connected to PE2, and enable MPLS on the interface connected to ASBR-PE1.
[ASBR-PE2] mpls lsr-id 162.1.1.1
[ASBR-PE2-mpls] lsp-trigger all
[ASBR-PE2-mpls] quit
[ASBR-PE2] mpls ldp
[ASBR-PE2-mpls-ldp] quit
[ASBR-PE2] interface vlan 310
[ASBR-PE2-Vlan-interface310] mpls
[ASBR-PE2-Vlan-interface310] mpls ldp
[ASBR-PE2-Vlan-interface310] quit
[ASBR-PE2] interface vlan 210
[ASBR-PE2-Vlan-interface210] mpls
[ASBR-PE2-Vlan-interface310] quit
# Configure basic MPLS capability on PE2 and enable LDP on the interface
connected to ASBR-PE2.
[PE2] mpls lsr-id 162.1.1.2
[PE2-mpls] lsp-trigger all
[PE2-mpls] quit
[PE2] mpls ldp
[PE2-mpls-ldp] quit
[PE2] interface vlan 310
[PE2-Vlan-interface310] mpls
[PE2-Vlan-interface310] mpls ldp
[PE2-Vlan-interface310] quit
3 Create a VPN instance on each PE, and bind the instance to the interface
connected to the corresponding CE.
To Next Page
Loading...
