620 CHAPTER 51: MPLS VLL
[3Com-mpls] static-lsp egress PEA-PEB l2vpn incoming-interface vlan-
interface 212 in-label 101
# Configure the remote connection.
[SW8800] ccc remote-connection interface vlan-interface 211 transmit
-lsp
PEB-PEA receive-lsp PEA-PEB
3 Configure P.
[PE_P] mpls lsr-id 10.0.0.2
[PE_P] mpls
[PE_P] vlan 214
[PE_P-vlan214] port gigabitethernet 2/1/1
[PE_P-vlan214] quit
[PE_P] interface Vlan-interface 214
[PE_P-Vlan-interface214] ip address 5.5.5.2 24
[PE_P-Vlan-interface214] mpls
[PE_P] vlan 212
[PE_P-vlan212] port gigabitethernet 2/1/2
[3Com-vlan212] quit
[PE_P] interface Vlan-interface 212
[PE_P-Vlan-interface212] ip address 6.6.6.2 24
[PE_P-Vlan-interface212] mpls
# Configure a static LSP, with the in-label of 100, the ingress interface being the
interface of VLAN 214, the out-label of 101, and the egress interface being the
interface of VLAN 212.
[PE_P-mpls] static-lsp transit PEA-PEB l2vpn incoming-interface vlan-
interface 214 in-label 100 nexthop 6.6.6.1 out-label 101
# Configure a static LSP, with the in-label of 200, the ingress interface being the
interface of VLAN 212, the out-label of 211, and the egress interface being the
interface of VLAN 211.
[PE_P-mpls] static-lsp transit PEB-PEA l2vpn incoming-interface vlan-
interface 212 in-label 200 nexthop 5.5.5.1 out-label 211
c
CAUTION: Following must be met to make a local CCC connection to go up:
■ The interfaces of the two CE are physically up.
■ The encapsulation types of the interfaces of the two CEs are the same and are
supported by the MPLS L2VPN.
For Layer 2 connections with the MPLS L2VPN being VLAN encapsulation, the
VLAN IDs of the interfaces of the two CEs can either be the same or different.
However, if a trunk is configured between the CEs and the PEs on both sides, the
VLAN IDs of the interfaces of the two CEs must be the same.
To Next Page
Loading...
