VPLS Basic Configuration Example 649
# Enable the ACL in port view.
[PE1] interface GigabitEthernet4/1/1
[PE1-GigabitEthernet4/1/1] packet-filter inbound link-group 4001 rule 1
2 Configure PE2
# Configure the Router ID used to advertise OSPF routing information. Generally,
the interface address of both MPLS LSI-ID and Loopback0 can be configured with
the same IP address.
[PE2] router id 1.2.3.4
# Configure mpls lsr-id. Enable MPLS and MPLS LDP globally.
[PE2] mpls lsr-id 1.2.3.4
[PE2] mpls
[PE2] mpls ldp
# Configure a 32-bit Loopback address, which is used to create LSP.
[PE2] interface loopback0
[PE2 -LoopBack0] ip address 1.2.3.4 32
# Configure a public VLAN, add a port to it, configure the IP address for the
interface. Then, enable MPLS and MPLS LDP on the interface.
[PE2] vlan 10
[PE2-vlan10] port GigabitEthernet 4/1/1
[PE2-vlan10] interface vlan 10
[PE2-vlan-interface10] ip address 10.10.10.11 24
[PE2-vlan-interface10] mpls
[PE2-vlan-interface10] mpls ldp enable
# Configure OSPF to set up routes.
[PE2] ospf
[PE2-ospf-1] area 0
[PE2-ospf-1-area-0.0.0.0] network 1.2.3.4 0.0.0.0
[PE2-ospf-1-area-0.0.0.0] network 10.10.10.11 0.0.0.255
[PE2-ospf-1-area-0.0.0.0] quit
[PE2-ospf-1] import-route direct
[PE2-ospf-1] quit
# Configure a LDP remote peer (PE1) to set up LDP session.
[PE2] mpls ldp remote-peer 1
[PE2-mpls-remote2] remote-ip 5.6.7.8
# Enable L2VPN globally.
[PE2] mpls l2vpn
# Configure a VPLS instance and VSI-ID (VPN-ID). Enter VSI-LDP view to configure
the IP address for PE1.
[PE2] vsi 3Com static
[PE2-vsi-3Com] pwsignal ldp
To Next Page
Loading...
