3Com 8807 - Page 816

816 CHAPTER 71: INFORMATION CENTER
2 Sending the configuration information to the console terminal
3 Sending the configuration information to the monitor terminal
Loghost
Refer to configuration
cases for related log host
configuration
- -
Table 765 Send the configuration information to the loghost
Device Configuration Default value
Configuration
description
Tabl e 766 Send the configuration information to the console terminal.
Device Configuration Default value
Configuration
description
Switch
Enable information center
By default, information
center is enabled.
Other configurations are
valid only if the
information center is
enabled
Set the information
output direction to the
Console
- -
Set information source -
You can define which
modules and information
to be sent out and the
time-stamp format of
information, and so on.
You must turn on the
switch of the
corresponding module
before defining output
debugging information
Enable terminal display
function
-
You can view debugging
information after enabling
terminal display function