834 CHAPTER 71: INFORMATION CENTER
The modules that allowed to output information are ARP and IP
Network diagram
Figure 194 Network diagram
Configuration procedure
1 Configuration on the switch
# Enable information center.
[SW8800] info-center enable
# Configure console terminal log output; allow modules ARP and IP to output
information; the severity level is restricted within the range of emergencies to
informational.
[SW8800] info-center console channel console
[SW8800] info-center source arp channel console log level informational
[SW8800] info-center source ip channel console log level informational
# Enable terminal display function.
<SW8800> terminal logging
console
3&
Switch
console
3&
Switch
console
3&
Switch
console
3&
Switch
To Next Page
Loading...
