NQA Configuration 863
Set the name of the VPN
instance
vpn-instance name
Optional;
By default, no name of the
VPN instance is set
Set the source IP address of
this test
source-ip ip-address
Optional;
By default, no source IP
address is configured. The
system uses the IP address of
the source interface as the
source IP address.
Set the source interface
source-interface {
interface-name |
interface-type
interface-number }
Optional;
By default, no source interface
is configured
Assume the connection mode
between the destination
address and the equipment
enabling the test as direct
connection mode
sendpacket passroute
Optional;
By default, no such
assumption
Set the number of the test
results that can be stored in
the history record
history-records number
Optional;
By default, 50 test results can
be stored in the history
record.
Set the condition (probe) of
sending Trap information to
the network management
system
send-trap { all | {
probefailure | testcomplete
| testfailure } * }
Optional;
By default, no Trap
information is sent to the
network management system.
Set the times of constant
probe fails after which the
Trap information is sent to the
network management system
probe-failtimes times
Optional;
By default, the system sends
the Trap information to the
network management system
after one probe fail.
Set the Trap information filter
condition (test)
test-failtimes times
Optional;By default, NQA
sends the Tap information to
the network management
system after one NQA test
fails.
Set the automatic test interval frequency interval
Optional;
The default interval time is 0,
that is, no automatic test is
performed;
Configure the interval>0,
then the system performs one
automatic test every
configured interval time
Enable the test test-enable
Required; (ignore this
configuration if you choose
the frequency interval
command to enable the
automatic test); generally, use
this command to enable tests.
Display the test result
display nqa { results |
history } [
administrator-name test-tag ]
The display command can be
executed in any view.
Table 818 Introduction to the configuration tasks of the ICMP test in NQA
Operation Command Remarks
To Next Page
Loading...
