Introduction to Password Control Configuration 875
Confirm :**********
Updating the password-file ,please wait...
# Enable password aging:
[SW8800] password-control aging enable
Password aging enabled for all users. Default: 90 days.
# Enable limitation of the minimum password length:
[SW8800] password-control length enable
Password minimum length enabled for all users. Default: 10 characters.
# Enable history password recording:
[SW8800] password-control history enable
Password history enabled for all users. Default: 10 history records
# Set the aging time of super passwords to 10 days:
[SW8800] password-control super aging 10
# Display the password control information of all users:
[SW8800] display password-control
Global password settings for all users:
Password aging: Enabled(90 days)
Password length: Enabled(10 Characters)
Password history: Enabled(Max history records:4)
Password alert-before-expire : 7 days
Password authentication-timeout : 60 seconds
Password attempt times : 3 times
Password attempt-failed action : Lock for 120 minutes
# Display the user names and the corresponding IP addresses added to the
blacklist because of password attempt failure:
[SW8800] display password-control blacklist
USERNAME IP
The number of users in blacklist is :0
# Delete the history password records of all users:
<SW8800> reset password-control history-record
Are you sure to delete all the history record?[Y/N]
If you type "Y", the system will delete the history records of all users and gives the
following prompt:
Updating the password file, please wait...
All historical passwords have been cleared.
To Next Page
Loading...
